阅读以下说明和流程图,填补流程图中的空缺(1)~(9),将解答填入答题纸的对应栏内。
【说明】
假设数组 A 中的各元素 A(1),A(2) ,…,A(M)已经按从小到大排序(M≥1);数组 B 中的各元素 B(1),B(2),…,B(N)也已经按从小到大排序(N≥1)。执行下面的流程图后,可以将数组A与数组B中所有的元素全都存入数组C中,且按从小到大排序(注意:序列中相同的数全部保留并不计排列顺序)。例如,设数组A中有元素:2,5,6,7,9;数组B中有元素:2,3,4,7;则数组C中将有元素:2,2,3,4,5,6,7,7,9。
【流程图】
The metric assigned to each network depends on the type of protocol. Some simple protocol, like RIP, treats each network as equals. The( )of passing through each network is the same; it is one( )count. So if a packet passes through 10 network to reach the destination, the total cost is 10 hop counts. Other protocols, such as OSPF, allow the administrator to assign a cost for passing through a network based on the type of service required. A( )through a network can have different costs (metrics). For example, if maximum( )is the desired type of service, a satellite link has a lower metric than a fiber-optic line. On the other hand, if minimum( )is the desired type of service, a fiber-optic line has a lower metric than a satellite line. OSPF allow each router to have several routing table based on the required type of service.
问题1选项
A.number
B.connection
C.diagram
D.cost
问题2选项
A.process
B.hop
C.route
D.flow
问题3选项
A.flow
B.window
C.route
D.cost
问题4选项
A.packet
B.throughput
C.error
D.number
问题5选项
A.delay
B.stream
C.packet
D.cost
在SNMP中,管理进程查询代理中一个或多个变量的值所用报文名称为( ),该报文的缺省目标端口是( )。
问题1选项
A.get-request
B.set-request
C.get-response
D.trap
问题2选项
A.160
B.161
C.162
D.163
报文摘要算法MD5的输出是( )位,SHA-1的输出是( )位。
问题1选项
A.56
B.128
C.160
D.168
问题2选项
A.56
B.128
C.160
D.168
网络由6个路由器互连而成,路由器之间的链路费用如下图所示,从PC机到服务器的最短路径是( ),通路费用是( )。
问题1选项
A.1→3→6
B.1→4→5→6
C.1→4→3→6
D.1→2→4→5→6
问题2选项
A.4
B.5
C.2
D.6
通过ADSL访问Internet,在用户端通过( )和ADSL Modem连接PC机,在ISP端通过( )设备连接因特网。
问题1选项
A.分离器
B.电话交换机
C.DSLAM
D.IP路由器
问题2选项
A.分离器
B.电话交换机
C.DSLAM
D.IP路由器
利用SDH实现广域网互联,如果用户需要的数据传输速率较小,可以用准同步数字系列(PDH)兼容的传输方式在每个STM-1帧中封装( )个E1信道。
网络系统设计过程中,逻辑网络设计阶段的任务是( )。
大型局域网通常划分为核心层、汇聚层和接入层,以下关于各个网络层次的描述中,不正确的是( )。
网络系统生命周期可以划分为5个阶段,实施这5个阶段的合理顺序是( )。
2009年发布的( )标准可以将WLAN的传输速率由54Mb/s提高到300~600Mb/s。